Snapper ST2046

Snapper ST2046The Snapper ST2046 is a 2WD lawn tractor from the ST series. This tractor was manufactured by Snapper (a part of Briggs & Stratton) during 2014. The Snapper ST2046 is equipped with two-cylinder gasoline engine and a belt-driven hydrostatic transmission with infinite forward and reverse gears.

The Snapper ST2046 lawn tractor used the Briggs & Stratton Intek 40R877 engine. It is a V-twin natural aspirated gasoline engine. This engine produced 20.3 PS (14.9 kW; 20.0 HP) at 3,600 rpm of output power.

The Snapper ST2046 is equipped with manual steering, an open operator station, 11.4 liters (3 US gal.; 2.5 Imp. gal) fuel tank, and a mid-mount 46 in (1,160 mm) mower deck with 2-blade and manual lift.

Snapper ST2046 Specifications

General Specifications
Model Snapper ST2046
Length 1,750 mm (68.9 in)
Width 1,440 mm (56.7 in)
Height 1,060 mm (41.7 in)
Wheel base –
Weight –
Fuel tank capacity 11.4 liters (3 US gal.; 2.5 Imp. gal)
Battery 12V, CCA 230A
Cabin type Open operator station
Engine
Engine model Briggs & Stratton 40R877 Intek
Engine type Four-stroke, air-cooled, V-twin
Cylinders 2
Fuel type Gasoline
Displacement 0.7 L, 655 cm2, (40.0 cu·in)
Bore and stroke 75.0 mm X 73.0 mm (2.95 in X 2.87 in)
Horsepower 20.3 PS (14.9 kW; 20.0 HP) at 3,600 rpm
Starter Electric
Transmission and chassis
Chassis 4×2 2WD
Steering type Manual
Brakes Disk
Transmission model Hydro-Gear T2
Transmission type Belt-driven hydrostatic
Gears Infinite forward and reverse
Speed Forward: 8.8 kmh (5.5 mph) Reverse: 4.8 kmh (3 mph)
Tires
Front tires Lawn/turf: 15×6.00-6
Rear tires Lawn/turf: 20×8.00-8
PTO (Power take-off shaft)
Front PTO type Independent with mechanical clutch
Front PTO speed –

4 Comments

Leave a Reply

Your email address will not be published.


*