AGCO Allis 6690

AGCO Allis 6690The AGCO Allis 6690 is a 2WD/4WD utility tractor from the 6600 series. This tractor was manufactured by SAME for distributor AGCO Allis in Italy from 1991 to 1997. The AGCO Allis 6690 is equipped with a 4.0 L (244.0 cu·in) four-cylinder diesel engine and one of four transmission varians.

The AGCO Allis 6690 utility tractor used the SLH 1000.4-AT engine. It is a 4.0 L, 3,998 cm2, (244.0 cu·in) four-cylinder turbocharged diesel engine with 105.0 mm (4.13 in) of the cylinder bore and 116.0 mm (4.57 in) of the piston stroke. This engine produced 88.1 PS (64.8 kW; 87.0 HP) at 2,500 rpm of output power.

The AGCO Allis 6690 is equipped with hydrostatic power steering, hydraulic wet disc brakes, flat-deck with four-post ROPS or cab (optional), and 107.0 liters (28.3 US gal.; 23.5 Imp. gal) fuel tank.

AGCO Allis 6690 Specifications

General Specifications
Model AGCO Allis 6690
Length 4,080 mm (160.6 in)
Width 2,090 mm (82.3 in)
Height 2,820 mm (111 in)
Wheel base 2WD: 2,440 mm (96.1 in)
4WD: 2,350 mm (92.5 in)
Ground clearance 440 mm (17.3 in)
Weight –
Fuel tank capacity 107.0 liters (28.3 US gal.; 23.5 Imp. gal)
Battery 12V, 100Ah
Cabin type Flat-deck with four-post ROPS or Cab (optional)
Engine
Engine model SLH 1000.4-AT
Engine type Four-stroke, air-cooled, inline
Cylinders 4
Fuel type Diesel
Displacement 4.0 L, 3,998 cm2, (244.0 cu·in)
Bore and stroke 105.0 mm X 116.0 mm (4.13 in X 4.57 in)
Horsepower 88.1 PS (64.8 kW; 87.0 HP) at 2,500 rpm
Starter Electric
Oil capacity: 8.7 L (9.2 US. qt, 7.7 Imp. qt.)
Transmission and chassis
Chassis 4×2 2WD or 4×4 MFWD 4WD
Steering type Hydrostatic power
Brakes Hydraulic wet disc
Transmission model –
Transmission type Synchromesh with dry disc clutch
Gears 12 forward and reverse
Speed Forward: 28.5 kmh (17.7 mph)
Transmission model –
Transmission type Partial power shift
Gears 30 forward and reverse
Transmission model –
Transmission type –
Gears 24 forward and 12 reverse
Transmission model –
Transmission type –
Gears 16 forward and reverse
Tires
Front tires Ag: 7.50-18 (2WD), 14.9R24 (4WD)
Rear tires Ag: 16.9R34
Three-Point Hitch
Category II/I
Control type Position and draft control with lower-link sensing
Lift capacity (at ends) 3,080 kg (6,790 lbs)
PTO (Power take-off shaft)
Rear PTO type Independent with hydraulic wet disc clutch
Rear PTO speed 540/1000 rpm
Hydraulic system
Hydraulic type Open center
Hydraulic capacity 57.5 L (15.2 US. gal, 12.6 Imp. gal.)
Valves 2
Pump flow 11.23 gpm (42.5 lpm)

Be the first to comment

Leave a Reply

Your email address will not be published.


*