International Harvester 4586

International Harvester 4586The International Harvester 4586 is a 4WD four-wheel drive tractor manufactured by Steiger in Fargo, North Dakota, USA for distributor International Harvester from 1976 to 1981. The International Harvester 4586 is equipped with a 13.1 L (798.0 cu·in) eight-cylinder diesel engine and a transmission with 10 forward and 2 reverse gears.

The International 4586 tractor used the International Harvester DV-800 engine. It is a 13.1 L, 13,077 cm2, (798.0 cu·in) eight-cylinder turbocharged diesel engine with 135.0 mm (5.31 in) of the cylinder bore and 114.0 mm (4.49 in) of the piston stroke. The compression ratio rating is 15.6:1. This engine produced 304.2 PS (223.7 kW; 300.0 HP) at 2,600 rpm of output power and 983.1 N·m (100.2 kg·m, 724.5 ft·lb) at 1,800 rpm of torque.

The IH 4586 is equipped with hydrostatic power steering, hydraulic wet disc brakes, cab with air-conditioning, and 643.5 liters (170 US gal.; 141.6 Imp. gal) fuel tank.

International Harvester 4586 Specifications

General Specifications
Model International Harvester 4586
Length
Width
Height
Wheel base 2,990 mm (117.7 in)
Ground clearance
Weight (operating) 11,680 kg (25,750 lbs)
Fuel tank capacity 643.5 liters (170 US gal.; 141.6 Imp. gal)
Battery 12V
Cabin type Cab with air-conditioning
Engine
Engine model International Harvester DV-800
Engine type Four-stroke, liquid-cooled, V
Cylinders 8
Fuel type Diesel
Displacement 13.1 L, 13,077 cm2, (798.0 cu·in)
Bore and stroke 135.0 mm X 114.0 mm (5.31 in X 4.49 in)
Compression ratio 15.6:1
Horsepower 304.2 PS (223.7 kW; 300.0 HP) at 2,600 rpm
Torque 983.1 N·m (100.2 kg·m, 724.5 ft·lb) at 1,800 rpm
Starter Electric
Transmission and chassis
Chassis 4×4 articulated 4WD
Steering type Hydrostatic power
Brakes Hydraulic wet disc
Transmission model
Transmission type
Gears 10 forward and 2 reverse
Speed Forward: 36.7 kmh (22.8 mph) Reverse: 5.3 (3.3 mph)
Tires
Front tires Ag: 24.5-32
Rear tires Ag: 24.5-32
Three-Point Hitch
Category IV
Control type
Lift capacity (at ends)
Hydraulic system
Hydraulic type
Pump flow 19.0 gpm (71.9 lpm)
ATTENTION! Dear visitors, this site is not a trading platform, an official dealer or a spare parts supplier, so we do not have any price lists, spare parts catalogs, service or owner manuals. We are an information portal and provide the technical specifications.

We try to use verified sources and official documentation, however, differences between sources or errors in entering information may occur. In addition, the characteristics may vary depending on the modification and market. We do not provide advice on technical issues related to the any operation or repair. We do not recommend using provided information for repairing or spare parts ordering, use only official service manuals and spare-parts catalogs.

Be the first to comment

Leave a Reply

Your email address will not be published.


*