John Deere 6105E

John Deere 6105EThe John Deere 6105E is a 2WD or 4WD utility tractor from the 6E series. This tractor has been manufactured by John Deere in Saltillo, Mexico since 2016. The John Deere 6105E is equipped with a 4.5 L (275.0 cu·in) four-cylinder diesel engine and one of two transmissions: a partial power shift transmission with 12 forward and 12 reverse gears or a two-speed power shift transmission with 24 forward and 12 reverse gears.

The JD 6105E utility tractor used the John Deere PowerTech PWL engine. It is a 4.5 L, 4,507 cm2, (275.0 cu·in) four-cylinder wastegate turbocharged diesel engine with air-to-air aftercooling, and 106.0 mm (4.17 in) of the cylinder bore and 127.0 mm (5 in) of the piston stroke. The compression ratio rating is 16.8:1. This engine produced 106.5 PS (78.3 kW; 105.0 HP) at 2,200 rpm of output power.

The John Deere 6105E is equipped with hydrostatic power steering, two-post foldable ROPS or Cab (optional).

John Deere 6105E Specifications

General Specifications
Model John Deere 6105E
Length –
Width –
Height –
Wheel base 2,450 mm (96.5 in)
Weight (ballasted) 6,465 kg (14,253 lbs)
Fuel tank capacity –
Battery 12V
Cabin type Two-post foldable ROPS or Cab (optional)
Engine
Engine model John Deere PowerTech PWL
Engine type Four-stroke, liquid-cooled, inline
Cylinders 4
Fuel type Diesel
Displacement 4.5 L, 4,507 cm2, (275.0 cu·in)
Bore and stroke 106.0 mm X 127.0 mm (4.17 in X 5 in)
Compression ratio 16.8:1
Horsepower 106.5 PS (78.3 kW; 105 HP) at 2,200 rpm
Torque 431.2 N·m (44 kg·m, 317.8 ft·lb) at 1,600 rpm
Starter Electric
Transmission and chassis
Chassis 4×2 2WD or 4×4 MFWD 4WD
Steering type Hydrostatic power
Brakes –
Differential lock Mechanical rear or limited-slip front differential (4WD)
Transmission model PowrReverser
Transmission type Partial power shift with wet disc clutch
Gears 12 forward and 12 reverse
Transmission model PowrReverser Hi-Lo
Transmission type Two-speed power shift with wet disc clutch
Gears 24 forward and 12 reverse
Tires
Front tires Ag: –
Rear tires Ag: –
Three-Point Hitch
Category II
Control type Draft sensing (optional)
Lift capacity (at 610 mm/24 in) 2,500 kg (5,515 lbs)
3,310 kg (7,300 lbs)
PTO (Power take-off shaft)
Rear PTO type Independent
Rear PTO speed 540/1000 rpm
Hydraulic system
Hydraulic type Open center
Pressure 2828 psi (195 bar)
Valves 2 to 3
Pump flow 20.0 gpm (75.7 lpm)

Be the first to comment

Leave a Reply

Your email address will not be published.


*